Versitron MCC-16RM Installationsanleitung PDF herunterladen (Seite 20)

20 www.versitron.com

Cold Start

When the power to the system is turned on, the system-start initialization and self-test process starts up. The self-

test messages are displayed as follows if a console connection is established successfully:

Power-on Self-test

------------------------------------------------------

$$$ System LOADER Checksum O.K !!!

$$$ System IMAGE Checksum O.K !!!

$$$ Sytem DATA Checksum O.K !!!

$$ Waiting Copy Rom to Sdram

$$$ System Power On Self Test....

$$$ ARM Reg R/W Test Success !!!

$$$ System EEPROM Checksum O.K !!

$$$ Get parameter O.K !!

My Mac Address is xxxxxxxxxxxx

------------------------------------------------------

This chapter describes the detailed console operation. It can be applied to either out-of-band console management

or in-band Telnet management. Both are the same in operation starting from the login prompt.

Direct Console Management

When you see the self-test messages shown on the screen properly, you can press <Enter> to start the console

Telnet Management

Use Telnet software to perform the management operation. The most convenient solution is using the built-in

Telnet function in a Windows 95/98/ or NT PC. Enter into the DOS window and invoke the following Telnet

command to connect to the system unit:

>telnet xxx.xxx.xxx.xxx

The specified xxx.xxx.xxx.xxx is the IP address of the system unit. A welcome message and login prompt are

displayed if the connection is established properly.

The following figure illustrates the login screen:

------------------------------------------------------

Welcome to Console

password:***

------------------------------------------------------

Username: admin

Factory default Password: 123

For security reason, the system supports a function to change the pass- word in setup menu. It is recommended to

change the default password immediately after a successful login.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 46 47

Keine Kommentare

Versitron MCC-16RM Installationsanleitung Seite 20