Versitron N7013x Series Installationsanleitung

N7013x Series 100BASE-FX Fiber Optic Network Interface Card Installation Guide 1 Copyright January 2005 VERSITRON, Inc. 83 Albe Drive / Suite C Newa

For PCI 2.2 Systems JP1 WOL connector and WOL cable are not required. WOL feature is accomplished through PCI 2.2 bus interface. To support remote wa

2. Installing the Adapter This chapter describes how to install the Fast Ethernet PCI adapter in a PCI computer and how to connect the adapter to th

Inserting the Adapter into the PCI Slot2.2 Configuring Wake-On-LAN If your system is a PCI 2.2 complaint system, no extra installation for WOL is re

Installing WOL Cable Note: The adapter provides PME signal with high active level. Make sure PME setting in BIOS options is properly set if it is a

When connecting to a 100BASE-FX device using fiber cable, make sure the TX connector of the adapter is connected to the RX con-nector of the devic

3. Network Driver Installation After making the connection to the network, you must install the adapter network driver in order to connect the Fast

3.3 Installation for Windows Systems For adapter installation on Windows XP, Windows 2000, WinME systems, the system will detect and configure the d

Link Speed/Duplex Mode options : Auto Mode FX port becomes 100M Full Duplex 100 Half Mode FX port becomes 100M Half Duplex Note: ot

4. LED Indicators Each Fast Ethernet adapter has three LEDs. The functions are: 4.1 Interpretations The interpretations of the LEDs are: Link LED in

Appendix A.1 Installing Remote Boot ROM Before you can use the remote boot function, you have to setup the remote boot service on the file server an

The information contained in this document is subject to change with- out prior notice. Copyright (C) All Rights Reserved. TRADEMARKS All

CE NOTICE Marking by the symbol indicates compliance of this equipment to the EMC directive of the European Community. Such

Table of Contents 1. Introduction ... 5 1.1 Adapter Features ... 5 1.2

1. Introduction The 100BASE-FX Fast Ethernet PCI Adapter is a 32-bit LAN adapter for use in personal computers with PCI computer bus slots.

1.2 Specifications Network port std.: IEEE 802.3u 100BASE-FX PCI slot: PCI 2.2 ACPI std.:

1.4 Board Components Figure 1-1 shows the major components on the adapter. The follow- ing table describes these components. No. Components

1.5 Wake On LAN Technology The adapter is an ACPI-compliant network adapter that supports the following features: - Power management interface - Remo

Wake-up Methods The adapter supports the following wake-up methods: - Magic packet wake-up The adapter can accept magic packets from network and walk